• Registered: 05-02-2015
  • Posts: 46

Topic: Simple plate-no results and missing error

Hi everyone,

could someone just have a brief look on the attached input file? I cant find a mistake in it.
After calculating, oofem doesnt show any errors but as you can see in the output file, there are no results.

Maybe someone could find the mistake?

Thanks a lot!
Dennis

Post's attachments

input_G.txt 96.7 kb, 3 downloads since 2018-05-28 

You don't have the permssions to download the attachments of this post.
  • Registered: 05-02-2015
  • Posts: 46

Re: Simple plate-no results and missing error

And the output file...

Post's attachments

output_G.txt 334.39 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.
  • Registered: 25-06-2013
  • Posts: 241

Re: Simple plate-no results and missing error

Hi,

I found out that you have 45 nodes with the same coords 3 0 8 0.0, so check your mesh that this is what you wnat.

Martin

  • Registered: 05-02-2015
  • Posts: 46

Re: Simple plate-no results and missing error

Thank you! I just found even more nodes with identical coords. So that should be the problem...

Dennis