Topic: Installation of oofem for a beginner...
I am on the way to install oofem using cygwin, but the Linux interface is completely new for me. If you could provide me some help on the following points, it will be so nice from you:
1) After having run the configure script in oofem-1.7, I get the following message:
“Modules to be included: oofemlib sm tm fm”
“target to be built: oofem-release”
What does that mean ?
2) By running ./configure –enable-oofeg, I get the message that the Elixir Library has not been found (But I have installed Elixir)
3) In order to build the utilities, I go to tools directory and when I run “make all” I get the message “ nothing to be done for `all` ” That`s a problem because I can not do the test as it requires the utilities.
4) The Readme file of oofem says:
“running oofem : the oofem program prints out the available options when run without any option. To run a specific job, you can enter : oofem -f input_file_name”
I Copy-pasted an input file in the oofem-1.7 folder, and when I go on Cygwin and type
" oofem -f NameOfTheFile.in " it says that the oofem command hasn`t been found. But when I just write
" NameOfTheFile.in ", it says that the lattice2D, the node, the boundaryConditions, the nsteps, the Direct, etc... hasn`t been found, even if they are defined in the file.
Could someone advice me on how to get these problems solved?
Many Thanks in advance