Differences

This shows you the differences between two versions of the page.

--- tools:salome_module [2015/04/28 15:47] – created bp
+++ tools:salome_module [2015/05/25 09:36] (current) – bp
@@ Line 1: / Line 1: @@
 ====== OOFEM Salome Module Tutorial ======
+The OOFEM Salome module is a plug-in module into [[http://www.salome-platform.org/|Salome platform]], which is established open-source software that provides a generic platform for Pre- and Post-Processing for numerical simulations. The OOFEM module adds a support for OOFEM:
+  * Ability to assign the boundary conditions, materials on the level of the geometrical model (to  defined groups)
+  * Ability to set up the complete model by selecting the components from the library and editing their properties within the salome
+  * Export the created model into oofem
 ===== Instalation =====
 In this installation tutorial, the SALOME_MODULE_DIR variable is a path to Salome module directory
-* Unpack module sources (OOFEM_SRC.tar.gz) into a Salome module directory (Salome_7.4.0 in my case)
+  * Unpack module sources (OOFEM_SRC.tar.gz) into a Salome module directory (Salome_7.4.0 in my case)
-* In the same directory create OOFEM_BUILD and OOFEM directories.
+  * In the same directory create OOFEM_BUILD and OOFEM directories.
-* run
+  * In the same directory define SALOME_MODULE_DIR
-  source env_build.sh
+  * <code>export SALOME_MODULE_DIR=$PWD</code>
-* run
+  * run <code>source env_build.sh</code>
-  export OOFEM_ROOT_DIR= SALOME_MODULE_DIR/OOFEM_BUILD/
+  * run <code>export OOFEM_ROOT_DIR=$SALOME_MODULE_DIR/OOFEM/</code>
-* change working directory to OOFEM_BUILD
+  * change working directory to OOFEM_BUILD <code>cd OOFEM_BUILD</code>
-* run
+  * run <code>cmake ../OOFEM_SRC -DCMAKE_INSTALL_PREFIX=${OOFEM_ROOT_DIR}
-  cmake ../OOFEM_SRC -DCMAKE_INSTALL_PREFIX=$(OOFEM_ROOT_DIR)
+sudo make install</code>
-  make install
+  * finally run salome <code>$SALOME_MODULE_DIR/KERNEL_7.4.0/bin/salome/runSalome -mGEOM,SMESH,OOFEM</code>
-* finally run salome
+===== Starting up =====
-  SALOME_MODULE_DIR/KERNEL_7.4.0/bin/salome/runSalome -mGEOM,SMESH,OOFEM
+  * After the installation is complete, you can run salome <code>export OOFEM_ROOT_DIR=$SALOME_MODULE_DIR/OOFEM/
+$SALOME_MODULE_DIR/KERNEL_7.4.0/bin/salome/runSalome -mGEOM,SMESH,OOFEM
+</code>
 ===== Tutorial =====