tools:salome_module
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tools:salome_module [2015/04/28 15:51] – [Instalation] bp | tools:salome_module [2015/05/25 09:36] (current) – bp | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== OOFEM Salome Module Tutorial ====== | ====== OOFEM Salome Module Tutorial ====== | ||
+ | The OOFEM Salome module is a plug-in module into [[http:// | ||
+ | * Ability to assign the boundary conditions, materials on the level of the geometrical model (to defined groups) | ||
+ | * Ability to set up the complete model by selecting the components from the library and editing their properties within the salome | ||
+ | * Export the created model into oofem | ||
+ | |||
===== Instalation ===== | ===== Instalation ===== | ||
In this installation tutorial, the SALOME_MODULE_DIR variable is a path to Salome module directory | In this installation tutorial, the SALOME_MODULE_DIR variable is a path to Salome module directory | ||
- | * Unpack module sources (OOFEM_SRC.tar.gz) into a Salome module directory (Salome_7.4.0 in my case) | + | |
- | * In the same directory create OOFEM_BUILD and OOFEM directories. | + | * In the same directory create OOFEM_BUILD and OOFEM directories. |
- | * run | + | * In the same directory define SALOME_MODULE_DIR |
- | source env_build.sh | + | |
- | * run | + | * run < |
- | | + | * run < |
- | * change working directory to OOFEM_BUILD | + | * change working directory to OOFEM_BUILD |
- | * run | + | * run < |
- | | + | sudo make install</ |
- | make install | + | * finally run salome |
- | * finally run salome | + | ===== Starting up ===== |
- | SALOME_MODULE_DIR/ | + | |
- | + | $SALOME_MODULE_DIR/ | |
+ | </ | ||
+ | |||
===== Tutorial ===== | ===== Tutorial ===== | ||
tools/salome_module.1430229100.txt.gz · Last modified: 2015/04/28 15:51 by bp