http://www.oofem.org/wiki/ 2008-11-21T08:37:17+01:00 http://www.oofem.org/wiki/ http://www.oofem.org/wiki/lib/images/favicon.ico text/html 2008-11-17T21:10:03+01:00 gercokees http://www.oofem.org/wiki/doku.php?id=installation&rev=1226952603&do=diff Getting oofem Getting release version You can get the release version of OOFEM from its download page. After downloading, unpack the distribution. For example on unix-like system, by running gunzip -c oofem-x.y.tar.gz | tar xof - Getting development (trunk) version Alternatively, you can get the bleeding edge version of OOFEM from the OOFEM SVN serve. To grab a copy of the latest version of OOFEM using anonymous svn access, use following command: text/html 2008-09-29T12:42:07+01:00 stephane.bordas http://www.oofem.org/wiki/doku.php?id=xfem&rev=1222684927&do=diff Discussion on the design of the implementation of Xfem into Oofem. The discussion is based on the description of the implementation in the paper Bordas S et al., An extended finite element library, Int. J. Numer. Meth. Engng, 2007 ---------- General comments * The most serious thing is that the xfem implementation, as described in the article, requires changes on the level of basic FEM classes, i.e. modification (extensions) of basic element and node classes. This has two principal drawbac… text/html 2008-07-30T10:41:12+01:00 gercokees http://www.oofem.org/wiki/doku.php?id=start&rev=1217407272&do=diff Welcome to the OOFEM wiki! The purpose of this resource is to promote collaboration between OOFEM users. Specifically, this page is not intended to replace the OOFEM forums, which are the proper place for detailed questions & discussions. This page should provide a basic knowledge base that can be used by both existing and new users and to demonstrate the capabilities of OOFEM. text/html 2008-07-03T10:33:51+01:00 gercokees http://www.oofem.org/wiki/doku.php?id=oofeg&rev=1215074031&do=diff To run OOFEG (graphic post-processor), you need job context file (*.osf, created by OOFEM when run with ”-c” command-line option, for example). If you have not created context file, only geometry can be displayed. To start oofeg, run it with the same input file name as you have run OOFEM: