User Tools

Site Tools


This is an old revision of the document!

Multiscale Heat Transport

Hydrating concrete produces significant amount of hydration heat, which causes several problems in massive concrete elements. Multiscale simulation helped to find an optimal position of cooling pipes and cooling regime on an arch of Opárno bridge, Czech republic. The bridge was built during 2008-2010 with the arches spanning 135 m, see Figures. ASCII ASCII

Two computational scales are defined here, see Figure on the right

  1. Level of cement paste. CEMHYD3D material model predicts the evolution of discrete microstructure on the scale of micrometers and returns liberated heat.
  2. Structural level. The heat balance equation is solved with finite elements. Several finite elements are grouped together and mapped to one CEMHYD3D instance. Nine OOFEM's instances are used in the simulation.

The Figures below show temperature evolution during concrete hardening, which are also animated. The simulation runs on a left symmetric part of the arch cross-section. Optimal position of cooling pipes is apparent. Note that the cooling turns off after several hours which detaches natural Dirichlet's boundary conditions and changes number of equations. The flat bottom subfigure shows the 2D triangular mesh and the assignment of hydration models to groups of finite elements on the cross-section. The right Figure validates the multiscale simulation with the temperature in the core of the cross-section. Temperature remained below 65C during summer casting, which was found acceptable.

oparno_02jpg.0132.jpg oparno_02jpg.0570.jpg


Created 12/2010 by Vít Šmilauer. Acknowledgements belong to B. Patzák, Z. Bittnar, J. L. Vítek and Pontex Consulting Engineers, Ltd.

gallery/multiscaleheattransport.1292441029.txt.gz · Last modified: 2010/12/15 20:23 by smilauer