Differences

This shows you the differences between two versions of the page.

--- gallery:multiscaleheattransport [2011/01/26 21:31] – smilauer
+++ gallery:multiscaleheattransport [2013/04/15 15:30] (current) – old revision restored bp
@@ Line 2: / Line 2: @@
 Hydrating concrete produces significant amount of hydration heat, which causes several problems in massive concrete elements. Multiscale simulation helped to find an optimal position of cooling pipes and cooling regime on an arch of Opárno bridge, Czech republic. The bridge was built during 2008-2010 with the arches spanning 135 m, see Figures.
 {{:gallery:dscn0032_small.jpg?300}}
 {{:gallery:dscn0026_small.jpg?300}}
@@ Line 10: / Line 11: @@
   - Structural level. The heat balance equation is solved with finite elements. Several finite elements are grouped together and mapped to one CEMHYD3D instance. Nine OOFEM's instances are used in the simulation.
-The Figures below show temperature evolution during concrete hardening, which are also {{:gallery:oparno_02.mpeg|animated}}. The simulation runs on a left symmetric part of the arch cross-section. Optimal position of cooling pipes is apparent. Note that the cooling turns off after several hours which detaches natural Dirichlet's boundary conditions and changes number of equations. The flat bottom subfigure shows the 2D triangular mesh and the assignment of hydration models to groups of finite elements on the cross-section. The right Figure validates the multiscale simulation with the temperature in the core of the cross-section. Temperature remained below 65<sup>o</sup>C during summer casting, which was found acceptable.
+The Figures below show temperature evolution during concrete hardening and induced out-of-plane stress when considering B3 model for concrete creep. The simulation runs on a left symmetric part of the arch cross-section. Optimal position of cooling pipes is apparent. Note that the cooling turns off after several hours which detaches natural Dirichlet's boundary conditions and changes number of equations. The flat bottom subfigure shows the 2D triangular mesh and the assignment of hydration models to groups of finite elements on the cross-section. The right Figure validates the multiscale simulation with the temperature in the core of the cross-section. Temperature remained below 65<sup>o</sup>C during summer casting, which was found acceptable.
 {{:gallery:oparno_02jpg.0132.jpg?300}}
@@ Line 16: / Line 17: @@
 {{:gallery:oparno_02.png?394}}
-{{:gallery:oparno_02.mpeg|Animation}} of temperature field during 100 hours after casting.
+{{mpeg>http://www.oofem.org/wiki/lib/exe/fetch.php?media=gallery:oparno_02tm.mpeg|Animation of temperature field during 100 hours after casting.}}
+{{mpeg>http://www.oofem.org/wiki/lib/exe/fetch.php?media=gallery:oparno_03sm.mpeg|Animation of out-of-plane stress under strain-plane condition.}}
-{{mpeg>{{:gallery:oparno_02.mpeg}}|Animation of temperature field}}
 //Created 12/2010 by Vít Šmilauer. Acknowledgements belong also to B. Patzák, Z. Bittnar, J. L. Vítek and Pontex Consulting Engineers, Ltd.//